Installing and Using VPN on Windows

1. If you are ON campus, connect to Ethernet and navigate to https://vpn-setup.bethel.edu/ in a browser.
   
   

2. If you are OFF campus, navigate to https://vpn.bethel.edu/ in a browser.

   The https:// is mandatory to access the installer.

3. Log in using your Bethel Username and Password.
   
   
   
4. Click Continue to agree to the Acceptable Use Policy.
   
   
   
5. Select AnyConnect from the bar at the left hand side of the screen.
   
   
   
6. Click Start AnyConnect.
   
   
   
7. The Cisco AnyConnect VPN Secure Mobility Client will go through a series of tests. Perform a manual installation by clicking on the AnyConnect VPN link.
   
   
   
8. Another window will appear. Click Save File. 
   
   
   
9. Follow the installer prompts. Click Next.
   
10. 
    
11. 
    
12. 
    
    
    
13. You have successfully installed the Cisco AnyConnect VPN Client.

Please note that if you are installing VPN on Bethel campus, you will not successfully connect to VPN until your computer is off the Bethel network.

1. Follow the instructions for /wiki/spaces/ITSKB/pages/50013768, and request the group "VPN Users".
   
   
2. Click on the Start button and select or search for the Cisco AnyConnect Secure Mobility Client.

2.  VPN will open. In the Connect To box, it should say vpn.bethel.edu. If not, type it in.
  

3. Select which VPN Tunnel you will be using and enter your Bethel username and password and click Connect.

4. Click Accept on the Acceptable Use Policy window that appears.

5. The VPN window will then disappear, but you will still be connected.You can access VPN again either through the Start menu or the Taskbar in the lower right-hand corner of the screen.

5. To confirm your connection, look for a green check mark and Connected to vpn.bethel.edu when you open the program.

6. To log out of VPN, open the program and click Disconnect. You can then close the window.